Product Description
The long anticipated Billet Sidecover for the GX200/Clone 196 and Predator Hemi Engine has arrived. It has the attention to detail and good looks that have come to be expected of ARC's billet products. It features side by side dual ball bearings that support the crank and gives it another fulcrum point to help eliminate any crankshaft flexing. It has an integral o-ring along the perimeter in it's machined groove that guarantees a good seal. 4 solid pin receptacles mate with solid dowels to increase mating shear strength. Bronze bushing(with ARC's advanced oil system) support for camshaft main increases strength and minimizes potential for wear. It has 2 venting holes at the top with 1/8" NPT Plugs. It also has 2 oil fill ports with billet ARC aluminum hand tighten plugs. Another useful feature is the threaded holes over the side dowel -pins so that small bolts (included) can be used to push the side cover for easy removal. Not compatible with electric start engines. Chain guard mounting hole thread size M8X1.25mm.
* Includes: Bearings, Seal, Gasket, O-Ring, Plugs and caps and installation hardware.
***Bolt torque 185-200 inch/lbs***
Also fits the Ducar 196/212cc, Tilltoson 196/212/225/235cc, Predator Ghost and Predator 224cc engines.
***use 14oz of oil in most applications***
***Some of the newer Predator Hemi and 212cc blocks will not have proper size dowel holes at the top and bottom of the block. You will need to drill them to proper size if you want all 4 dowels in the sidecover***
* Important * Due to variations in blocks, you may find that the side cover is not quite lining up with all four dowel pins. Try removing the bottom dowel pin if you encounter difficulty. Contact our tech department if you have any problems.
Will Not fit old style Harbor Freight Greyhound or Predator 212 Non Hemi engine.
Will Not work with Stud Kit. Must use the bolts in the kit.
Product Videos
Custom Field
Product Reviews
28 Reviews Hide Reviews Show Reviews
-
Cam clearance caution
Since this new cover has a bushing for the cam,the material around the bushing can come in contact with the studs on the cam gear that hold the spring loaded lifter, 14mm ID shims or thrust washers are needed or else contact between the two can happen, depending on the cam and tolerance on that cam