Product Description
The Mongrel Clutch...
A little bit of the best of everything!
After racing the Box Stock class for years, we have never been fully satisfied with any clutch. Several have done a great job but each lacked something that the other had. What I wanted was an affordable multi-shoe drum clutch that "hit" right, had a nice stamped drum with machined friction surfaces, and used SMC/Bully style drive sprockets with needle bearings.
I have been most satisfied with the slip and lock-up features of the MaxTorque Racing clutch, but the center hub was too soft for the needle bearings of the sprockets I wanted to use. So we had a hardened, two-piece hub made that would act as a good inner race for the needle bearings. We got a stamped steel drum that is a little deeper than other drums. The drum is made of thicker metal to allow critical surfaces to be machined so they are flat and square, minimizing run-out and warpage from heat.
The sprockets we supply with the clutch are made by Tomar, but the clutch has several internal spacers that can be removed as needed to accommodate similar gears. So use whatever sprockets you have, and add or remove shims to obtain the same amount of play the drum and sprocket has on the hub when the clutch is new out of the box.
The clutch comes with a spacer washer that is chamfered on the inside of one side. This spacer goes on the crank first and the chamfer goes toward the engine. The clutch can then be mounted either in-board or out-board using the supplied key and snugged-up with the included bolt and outside washer. DO NOT INSTALL THE CLUTCH WITHOUT THE PROPER SPACERS. It must be spaced enough to allow it to move very slightly on the crank after tightening the bolt. Too tight will damage the hub requiring premature replacement. The clutch has plenty of play built in if you use the right amount of internal shims mentioned in the previous paragraph.
Keep the clutch clean by blowing dirt and debris out with compressed air. It is ok to spray the entire clutch lightly with WD-40, however be sure to wipe down the inside of the drum before re-assembling. Lube the sprocket's needle bearings with a drop or two of gear lube after cleaning. Do not get Teflon anywhere near a drum clutch.
The clutch will "stall" or begin pulling around 3100 RRM.
For use on 3/4" PTO and #35 chain.
This clutch is best suited for engines less than 15HP
***Please note that it is not possible to use needle bearings with 12 and 13 tooth gears. They have bronze bushings***
Product Videos
Custom Field
Product Reviews
11 Reviews Hide Reviews Show Reviews
-
great product
Great product and very fast shipping
-
Mongrel Clutch
Best clutch for the money. Ran this clutch for a season and a half with zero maintenance and had zero problems.
-
According to the book this is the clutch type we needed for box stock clone.
My son and myself can race the same kart in 2 classes. Hopefully it gets us where we need to be. Mounted but not taken to the track yet for opinion but reviews were positive which got my attention to give it a whirl
-
best clutch for the money
My son runs purple plate predator class and we run this clutch against the best disc clutch brands out there and are running up front with them and winning with this mongrel clutch love it
-
Mongrel clutch
Great starter clutch for us, can't wait to get it out to track.
-
Best place to get parts
First off ARC is awesome have bought stuff many times from them. The clutch has almost no restance to spin and well worth the money
-
Clutch
Just what I ordered
-
Best upgrade
smoothest clutch I've ever owned definitely keeeping it a secret
-
Excellent
He was right this clutch has a little of everything i just tell my friends yea its a max torque im keeping this clutch a secret its so good