800-521-3560
ARC Racing 6600-PH ultra-lite billet flywheel designed for Predator 212 Hemi engines running PVL ignition systems. Weighing only 1.6 lbs, this SFI-certified flywheel delivers extremely quick throttle response and stable ignition performance for kart racing and high-RPM performance engines. See full product details below.
The factory Predator 212 Hemi blower housing extends farther outward than the Non-Hemi housing. This extra depth can prevent the starter cup from reaching the ARC 6600-PH billet flywheel properly.
To correct this issue, replace the factory Hemi blower housing with the DJ-1200B Clone Blower Housing. Check starter cup fitment and pull starter engagement before operating the engine.
Photo reference: Non-Hemi housing on the left; Hemi housing on the right.
The ARC Racing 6600-PH billet flywheel is an ultra-lightweight performance flywheel engineered specifically for Predator 212 Hemi engines running a PVL digital ignition system. At only 1.6 lbs, it is one of the lightest flywheels available for this engine platform, delivering extremely fast throttle response and improved engine acceleration.
Precision-machined from billet aluminum and SFI certified, the 6600-PH replaces the factory cast flywheel with a race-ready component designed for safe high-RPM operation. The lightweight design reduces rotating mass, allowing the engine to accelerate faster while maintaining stable ignition timing.
This flywheel is designed specifically for use with the 710106 PVL ignition coil and includes the required coil mounting bracket for proper installation. The timing is preset at approximately 29° BTDC when installed using a standard flywheel key.
Important: This flywheel fits only Predator 212 Hemi engines and will not fit Non-Hemi Predator or Honda GX200/Clone crankshafts.
Important Fitment Notice: This flywheel fits ONLY Predator 212 Hemi engines. It will NOT fit Predator 212 Non-Hemi engines, Honda GX200 engines, or 196cc clone platforms.
The ARC 6600-PH billet flywheel is designed specifically for Predator 212 Hemi engines (Gen 2 with cast aluminum valve cover).
This flywheel must be used with the 710106 PVL ignition coil and includes the required coil mounting bracket.
The flywheel is preset at approximately 29° BTDC when installed with a standard flywheel key.
ARC Racing recommends tightening the flywheel nut to 54 ft/lbs. Do not exceed this torque value.
No. The 6600-PH flywheel is designed specifically for Predator 212 Hemi engines and will not fit Non-Hemi Predator or Honda/Clone crankshafts.
Complete your Predator 212 Hemi engine build with ARC Racing billet performance components including billet connecting rods, billet crankshafts, billet sidecovers, and high-performance billet flywheels engineered for kart racing and high-RPM small engine performance.
(4)
